Accessories for Nerf Instructions

Thank you for ordering one of our Nerf Accessories! You can find more barrels, grips, sites, and more here!

 

Since Nerf guns are made of plastic we find that the tactical rails, and barrel connectors wear down over time. This can cause our products to fit well on some guns, but not at all on others.

 

To remedy this we have decided to make our accessories a little snug.

If you find that an item is too tight follow the steps below for a good fit.

1. Use a hair dryer, or heat gun to heat the connector on the accessory.

2. Place the accessory on your Nerf gun.

3. Allow the accessory to cool.

4. Repeat until you achieve the desired fit.

For more info on finishing and painting your accessories check out our general instructions page.